2" Brass Ball Valve, 2 Piece

The valve body is made of high-quality brass forging to prevent leakage. Brass ball valve is manufactured by a high-precision special machine with low flow resistance. The medium inside the valve body has a straight channel, and the medium flows in a straight line.

Specification

• Model: ATO-BBV-DN50
• Nominal Diameter: DN50
• Nominal Pressure: 1.6MPa
• Size: 2 inch
• Body Material: Brass
• Connection Type: Thread
• Standard: Compliant with ISO 228 Standard
• Structure: Fixed Ball Valve
• Applicable Temperature: -10℃≤T≤120℃
• Valve Action: Flow Control
• Mode of Action: Double Acting
• Channel Location: Straight
• Sealing Material: Rubber
• Sealing Method: Soft Seal
• Drive Mode: Manual
• Flow Direction: Bidirectional
• Working Medium: Water, Oil, Non-Corrosive and Non-Combustible Gas
• Weight: 1400g

Dimensions & Details (Unit: mm)

Tips: What is a fixed ball valve?

The fixed ball valve has two body structures: two-piece and three-piece. The middle flange is connected by bolts. The seal is made of reinforced PTFE and embedded in the stainless steel ring. The rear of the steel ring is provided with a spring to ensure that the valve seat is close to the ball. Keep sealed. The upper and lower valve stems are equipped with PTFE bearings to reduce friction and save labor. There is an adjustment plate at the bottom of the small shaft to ensure the joint position of the ball and the sealing ring. Full bore: The valve flow aperture is consistent with the inner diameter of the pipeline, so that the pipeline can be cleaned.