Close
(0) Shopping cart
You have no items in your shopping cart.
Shopping Categories
    Filters
    Preferences
    Search

    5 kVA Single Phase Variac Voltage Regulator

    $758.65
    Discounted 5 kVA contact voltage regulator, single phase for generator, with 50Hz working frequency and 20A rated output current. Low cost and factory direct sales.
    SKU: ATO-VVR-5K
    Free shipping
    Delivery date: 6-12 days

    5 kVA Single Phase Variac Voltage Regulator Features

    • 5 kVA and single phase.
    • Better protection, high quality workmanship.
    • 20A rated output current and 0-250V rated output voltage, 220V rated input voltage.
    • Widely used in various power supply sites with frequency 50Hz.
    • High quality and safety variac voltage regulator.

    5 kVA Single Phase Variac Voltage Regulator Specifications

    Model TDGC2-5K
    Weight 15.6 kg
    Phase No 1
    Frequency 50 Hz
    Rated input voltage 220V
    Rated output voltage 0-250V
    Rated capacity 5 kVA
    Rated output current 20A
    Usage SVC
    Current Type AC
    Type Contact type regulators
    Dimension L 330mm
    W 270mm
    H 310mm

    5 kVA Single Phase Variac Voltage Regulator Detail

    5 kVA single phase variac voltage regulator

    Tips: Installation and use

    • For newly installed or long-term unused voltage regulator, a 500V megger shall be used to measure the insulation resistance of coil to ground before operating it. It can be safely used only when the resistance is no lower than 5megohm, otherwise it shall be heated in advance. Heating treatment can be realized with charged drying method or drying in the oasthouse,. After heating treatment, check whether the fasteners are loose. If they are, tighten them.
    • The supply voltage should comply with the rated input voltage on the regulator nameplate.
    • The voltage regulator shall be well grounded to ensure safety.
    • Notice that the output current doesn’t exceed the rated value when using. If there is a short-term load, it can not exceed the requirement of 120%/1min, otherwise it may reduce the service life of voltage regulator or even burn the voltage regulator.
    • When using, the handle should be rotated evenly and slowly, so as not to cause the brush to damage or spark.
    • Check the service conditions regularly. If the brush is found to be excessively worn or damaged, replace a new one and polish the bottom surface of brush with placing a 0 sand paper under the brush, it can be used after well connection. The replaced copper graphite composite brush shall strictly comply with specification requirements.
    Write your review for 5 kVA Single Phase Variac Voltage Regulator
    • Only registered users can write reviews
    • Bad
    • Excellent